| Symbol | - |
|---|---|
| Unit | -- |
| Attribute-ID | result_transmission_error |
| Numeric ID | 10433 |
| Value Type | PMTechArray |
Specification of whether the course and range of the transmission error should be calculated and output.
The transmission error x(t) is a vibration and noise excitation function of gears. The transmission error describes the irregular form of the rotational movement between two rolling contact partners at a very low rotational speed n → 0.
In this case, the total meshing force F is constant for every mesh position. The sum of the load distribution of every mesh point is equal to the tooth load F = const.
The path x of both partners relative to each other is evaluated. A path between the pinion and gear results in each engagement position due to the load distribution and the local stiffness and deviation ratios.
When the values of all of these paths between the pinion and the gear along the generating path axis are entered, the transmission error can be obtained.
Illustration & Formula: Transmission Error
| A | Load distribution |
| B | Path of tooth contact |
| I | Mesh position I |
| II | Mesh position II |
| I, II, ... | All mesh positions |
| x | Rotational travel |
| t | Generating path |
| F | Tooth load (=const.) |
| czi | Local rigidities in tooth contact |
| xfi | Local form deviations of the tooth contact |
The local form variations of the tooth contact xfi include both desired form variations, such as flank corrections, and unwanted form variations, such as manufacturing deviations. Skewing and deformations of the shaft-bearing system are also interpreted as form variations of the tooth contact.
For analysis of the gearing vibration, the transmission error is broken down into its Fourier components. The result is a spectrum of rotational travel amplitudes û.
Spectrum of rotational travel amplitudes û
The order of the transmission error in the spectrum corresponds to the order of the gear mesh frequency fz.
Advantages:
The transmission error can be determined by measuring. Thus, the calculation can be validated and compared to the real gear.
Disadvantages:
The transmission error is not suitable for comparing gears with different main geometry. It is best suited for evaluating the influence of flank corrections with the same main geometry.
The transmission error is dependent on the torque, and must be determined separately for each torque. If the excitation of the gear needs to be optimized for a specific torque range, flank corrections are often used. These are designed such that the transmission error and its amplitudes are as small as possible for the optimized torque range.