| Symbol | - |
|---|---|
| Unit | -- |
| Attribute-ID | result_force_excitation |
| Numeric ID | 13424 |
| Value Type | PMTechArray |
Specification of whether the course and the range of the meshing force should be calculated and output.
The meshing force F is a vibration and noise excitation function of gears.
It is defined similar to the transmission deviation, but with the other limiting case of an infinitely high speed of rotation.
Here, the deflection in the mesh is constant and corresponds to the average value of rotational travel. It is an abstract observation: at an infinite speed, neither the teeth nor the gear bodies could make compensating movements or deform (mass insulation). The irregular forms between the rolling partners are reflected in force changes.
| Fz | Tooth load |
| t | Generating path |
| x | Rotational travel (const.) |
| xfi | Local form variations of the tooth contact |
| czi | Local rigidities in tooth contact |
The local form variations of the tooth contact xfi include both desired form variations, such as flank modifications, and unwanted form variations, such as manufacturing deviations. Skewing and deformations of the shaft-bearing system are also interpreted as form variations of the tooth contact.
Similar to the transmission deviation, the meshing force is displayed as a curve over the generating path.
For analysis of the gearing vibration, the meshing force is broken down into its Fourier components. The result is a spectrum of meshing force amplitudes û.
| û(N) | Amplitude of the meshing force |
| Ord. fz | Order of fz |
Analysis of the gearing vibration using the meshing force:
The order of the meshing force in the spectrum corresponds to the order of the gear mesh frequency fz. Thus, an association with a measurement, such as structure-borne noise, can be created: if a specified order of the meshing force is lower in comparison to a reference gear then this behavior can also be expected in the measurement results.
Advantages:
The meshing force is best suited for the comparison of gears with different main geometry, as well as the evaluation of the influence of flank modifications with the same main geometry.
Disadvantages:
The meshing force can only be approximately determined from measurements.
It is dependent on the torque, and must be determined separately for each torque.